DTC B1787 Rear Occupant Classification Sensor LH Collision Detection |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1787 |
|
|
| 1.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
Using the Techstream, perform Zero Point Calibration and Sensitivity Check (Click here).
|
| ||||
| OK | |
| 2.CHECK DTC |
Clear the DTCs stored in the occupant detection ECU (Click here).
Clear the DTCs stored in the airbag sensor assembly (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON (IG).
Check for DTCs (Click here).
Turn the ignition switch off.
|
| ||||
| OK | ||
| ||
| 3.REPLACE SEPARATE TYPE FRONT SEAT CUSHION SPRING ASSEMBLY |
Disconnect the cable from the negative (-) auxiliary battery terminal.
Replace the separate type front seat cushion spring assembly (Click here w/ Non-removable Headrest, Click here w/ Removable Headrest).
Connect the cable to the negative (-) auxiliary battery terminal.
| NEXT | |
| 4.PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK |
Using the Techstream, perform Zero Point Calibration and Sensitivity Check (Click here).
| NEXT | ||
| ||