LIGHTING SYSTEM > Rear Door Courtesy Switch Circuit |

| 1.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| RR Door Courtesy SW | Rear door courtesy light switch RH signal/ON or OFF | ON: Rear door RH open OFF: Rear door RH closed | - |
| RL Door Courtesy SW | Rear door courtesy light switch LH signal/ON or OFF | ON: Rear door LH open OFF: Rear door LH closed | - |
| Result | Proceed to |
| OK | A |
| Rear door courtesy light switch LH or RH does not operate | B |
|
| ||||
| A | ||
| ||
| 2.INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (LH OR RH) |
Remove the rear door courtesy light switch assembly (Click here).
Inspect the rear door courtesy light switch assembly (Click here).
| Result | Proceed to |
| OK (for Rear LH) | A |
| OK (for Rear RH) | B |
| NG | C |
|
| ||||
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY LH - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)) |
Disconnect the G59 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M3-1 - G59-1 (LCTY) | Always | Below 1 Ω |
| M3-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)) |
Disconnect the G59 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M4-1 - G59-6 (RCTY) | Always | Below 1 Ω |
| M4-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||