Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold Tire Inflation Pressure:

    Tire Size
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    P175/65R15 84H
    240 (2.4, 35)
    230 (2.3, 33)
    P195/50R16 83V
    220 (2.2, 32)
    200 (2.0, 29)



    C164558
  1. Using a dial indicator, check the runout of the tires.

    Maximum tire runout:
    Vertical:
    1.4 mm (0.0551 in.)
    Lateral:
    2.0 mm (0.0787 in.)



2. ROTATE TIRES


    C196349
  1. Rotate the tires as shown in illustration.
    Text in Illustration 
    V100135
    Front

    Torque:
    103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



3. INSPECT AND ADJUST WHEEL BALANCE


  1. Inspect and adjust the off-the-car balance.

    1. Steel wheel:

      Maximum imbalance:
      8.0 g (0.0176 lb)



    2. C144018E10
    3. Others (Non-steel wheel):
      Text in Illustration 
      *a
      25 mm (0.984 in.)

      Maximum imbalance:
      8.0 g (0.0176 lb)

      NOTICE:
      1. Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
      2. Do not touch the adhesive surface of the balance weight.
      3. Adhere a stick-on type balance weight to the flat surface*a shown in the illustration.
      4. Push the balance weight with your finger to securely adhere it to the desired position.
      5. Do not reuse balance weights.

      HINT:
      Use clip-on type balance weights for the inner side, and stick-on type balance weights for the outer side.



4. INSPECT FRONT AXLE HUB BEARING
(Click here)


5. INSPECT REAR AXLE HUB BEARING
(Click here)