Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(Click here)


2. REMOVE INNER COWL TOP TO COWL BRACE


    C250011
  1. Remove the 3 bolts and inner cowl top to cowl brace.



3. REMOVE FRONT AIR SHUTTER SEAL


    C250012
  1. Disengage the clamp to remove the front air shutter seal.



4. REMOVE FRONT NO. 1 VENTILATOR SEAL


    C250013
  1. Disengage the clamp to remove the front No. 1 ventilator seal.



5. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY


    C250014
  1. Disengage the clamp to separate the wire harness from the outer cowl top panel sub-assembly.



    C250015
  1. Remove the 8 bolts, nut and outer cowl top panel sub-assembly.



6. REMOVE FRONT WHEEL


7. SEPARATE FRONT STABILIZER LINK ASSEMBLY


    C249870
  1. Remove the nut and separate the front stabilizer link assembly from the front shock absorber assembly.

    HINT:
    Use a hexagon socket wrench to hold the stud.



8. SEPARATE FRONT FLEXIBLE HOSE


    C107502
  1. Remove the bolt and separate the front speed sensor and front flexible hose.



9. REMOVE FRONT SUSPENSION SUPPORT DUST COVER
  1. Remove the front suspension support dust cover.



10. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING


    C249897E01
  1. Support the front lower No. 1 suspension arm sub-assembly using a jack and wooden block.
    Text in Illustration 
    *1
    Wooden Block
    *2
    Jack



    C249872
  1. Remove the 2 nuts and 2 bolts, and separate the front shock absorber with coil spring from the steering knuckle.

    NOTICE:
    When removing the nuts, keep the bolts from rotating.



    C249865
  1. Using a hexagon socket wrench, hold the front shock absorber rod and remove the nut.

  1. Remove the front No. 2 suspension support.

  1. Remove the front shock absorber with coil spring from the vehicle.



11. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY


12. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


    C107505
  1. Using a hexagon socket wrench, hold the front shock absorber rod and loosen the front support to front shock absorber nut.



    C107506E03
  1. Using SST, compress the front coil spring.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

    NOTICE:
    Do not use an impact wrench. It will damage SST.

  1. Remove the front support to front shock absorber nut.



13. REMOVE FRONT NO. 1 SPRING BUMPER SUB-ASSEMBLY
  1. Remove the front No. 1 spring bumper sub-assembly from the front shock absorber assembly.



14. REMOVE FRONT UPPER COIL SPRING INSULATOR


15. REMOVE FRONT COIL SPRING


16. REMOVE FRONT SHOCK ABSORBER ASSEMBLY