Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM

FRONT LOWER SUSPENSION ARM > REMOVAL

for Preparation Click here


HINT:
The front lower No. 1 suspension arm sub-assembly LH can be removed directly from the vehicle.



1. REMOVE FRONT WHEEL


2. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH


    C107513
  1. Remove the clip and nut.



    C172759E06
  1. Install SST to the threaded section of the lower ball joint.

    SST
    09960-20010   (09961-02060)

    NOTICE:
    Make sure that the upper ends of the threaded section of the lower ball joint and SST are aligned.



  1. Using SST, separate the front lower No. 1 suspension arm sub-assembly LH from the steering knuckle.

    SST
    09960-20010   (09961-02010, 09961-02060)


    C236386E01


    Text in Illustration 
    *a
    Apply grease
    *b
    Place wrench here

    CAUTION:
    Apply grease to the threads and end of the SST bolt.

    NOTICE:
    1. Make sure to tie the string of SST to the vehicle to prevent SST from dropping.
    2. Install SST so that A and B are parallel.
    3. Be sure to place the wrench on the part indicated in the illustration.
    4. Do not damage the lower ball joint dust cover.
    5. Do not damage the drive shaft outboard joint boots.
    6. Do not damage the front disc brake dust cover.
    7. Do not damage the steering knuckle.



3. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH


    C249878
  1. Remove the 2 bolts and front lower No. 1 suspension arm sub-assembly LH from the front suspension crossmember sub-assembly.



4. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
(Click here)