Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR

FRONT SPEED SENSOR > REMOVAL

for Preparation Click here


NOTICE:
  1. Use the same procedure for the LH side and RH side.
  2. The following procedure is for the LH side.
  3. If the sensor rotor needs to be replaced, replace the front axle hub bearing.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL
(Click here)


3. REMOVE FRONT FENDER LINER

HINT:
Use the same procedure for the LH side and RH side (Click here).



4. REMOVE FRONT SPEED SENSOR


  1. Disengage the clamp from the body.


    C234706E01


    Text in Illustration 
    *1
    No. 1 Clamp
    *2
    No. 2 Clamp
    *3
    No. 3 Clamp
    -
    -

  1. Disconnect the front speed sensor connector.

  1. Remove the No. 3 clamp from the body.

  1. Disengage the 2 clamps from the body.

  1. Remove the bolt and separate the No. 2 clamp from the body.

  1. Remove the bolt and separate the No. 1 clamp from the shock absorber.

  1. Remove the bolt and front speed sensor from the steering knuckle.

    NOTICE:
    1. Keep the front speed sensor tip and installation portion free of foreign matter.
    2. Remove the front speed sensor without turning it from its original installation angle.