SFI SYSTEM > Fuel Pump Control Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (CONTROL THE FUEL PUMP / SPEED) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check whether the fuel pump with filter assembly operating sound occurs when performing the Active Test on the Techstream.
| Result | Proceed to |
| Fuel pump with filter assembly operating sound does not occur | A |
| Fuel pump with filter assembly operating sound occurs | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - ECM) |
Remove the No. 1 integration relay from the No. 2 engine room relay block and No. 2 junction block assembly.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2D-4 - A40-21 (FC) | Always | Below 1 Ω |
| 2D-4 or A40-21 (FC) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - FUEL PUMP WITH FILTER ASSEMBLY) |
Remove the No. 1 integration relay from the No. 2 engine room relay block and No. 2 junction block assembly.
Disconnect the fuel pump with filter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2D-8 - M22-4 (B) | Always | Below 1 Ω |
| 2D-8 or M22-4 (B) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (FUEL PUMP WITH FILTER ASSEMBLY - BODY GROUND) |
Disconnect the fuel pump with filter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M22-5 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.INSPECT FUEL PUMP WITH FILTER ASSEMBLY |
Inspect the fuel pump with filter assembly (Click here).
|
| ||||
| OK | |
| 6.INSPECT NO. 1 INTEGRATION RELAY (C/OPN RELAY) |
Inspect the No. 1 integration relay (C/OPN relay) (Click here).
|
| ||||
| OK | ||
| ||