STEERING KNUCKLE > REMOVAL |
| 1. REMOVE FRONT AXLE ASSEMBLY |
| 2. REMOVE FRONT AXLE HUB HOLE SNAP RING |
![]() |
Using snap ring pliers, remove the axle hub hole snap ring.
| 3. REMOVE FRONT AXLE HUB SUB-ASSEMBLY |
Secure the front axle assembly between aluminum plates in a vise.
![]() |
Using SST, remove the front axle hub sub-assembly.
![]() |
Using SST, remove the axle hub bearing inner race.
| *a | Turn |
| *b | Hold |
| 4. REMOVE FRONT DISC BRAKE DUST COVER |
![]() |
Remove the front disc brake dust cover by tapping the back with a brass bar and hammer.
| 5. REMOVE STEERING KNUCKLE |
Install the removed front axle hub bearing inner race onto the outer side of the front axle hub bearing.
![]() |
Using SST and a press, remove the front axle hub bearing.