Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM

DTC    B1630/23    Rear Airbag Sensor RH Circuit Malfunction

for Preparation Click here


DESCRIPTION

The side collision sensor RH circuit (to determine deployment of the front seat airbag assembly RH, curtain shield airbag assembly RH and front seat outer belt assembly RH) is composed of the airbag sensor assembly, side airbag sensor assembly RH, side No. 2 airbag sensor assembly RH and door side airbag sensor RH.
The side No. 2 airbag sensor assembly RH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbag should be deployed.
DTC B1630/23 is stored when a malfunction is detected in the side No. 2 airbag sensor assembly RH.

DTC No.
DTC Detection Condition
Trouble Area
B1630/23
  1. Side No. 2 airbag sensor assembly RH malfunction
  2. Airbag sensor assembly malfunction
  1. Side No. 2 airbag sensor assembly RH
  2. Airbag sensor assembly

WIRING DIAGRAM

Refer to DTCs B1622/81, B1623/81, B1632/81, B1633/81, B1642/81, B1692/81 and B1693/81 .

INSPECTION PROCEDURE

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).

1.CHECK SIDE NO. 2 AIRBAG SENSOR ASSEMBLY RH


    C238223E01
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

  1. Interchange the side No. 2 airbag sensor assembly RH with LH and connect the connectors.

  1. Connect the cable to the negative (-) auxiliary battery terminal.

  1. Clear the DTCs stored in memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON (IG), and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC B1630/23 is output.
    A
    DTC B1635/24 is output.
    B
    DTCs B1630/23 and B1635/24 are not output.
    C

    HINT:
    Codes other than DTCs B1630/23 and B1635/24 may be output at this time, but they are not related to this check.

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

  1. Return the side No. 2 airbag sensor assembly RH and LH to their original positions and connect the connectors.
    Text in Illustration 
    *1
    Side No. 2 Airbag Sensor Assembly LH
    *2
    Side Airbag Sensor Assembly RH



B
REPLACE SIDE NO. 2 AIRBAG SENSOR ASSEMBLY RH (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE AIRBAG SENSOR ASSEMBLY (Click here)