Home › Engine / Hybrid System › 1NZ-FXE STARTING › IGNITION SWITCH

IGNITION SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY
  1. Engage the 2 claws to install the ignition or starter switch assembly.



2. INSTALL UPPER STEERING COLUMN WITH SWITCH BRACKET ASSEMBLY
  1. Set the steering column assembly in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.



    C233278
  1. Install the upper steering column with switch bracket assembly with a new steering lock set bolt, and then tighten the bolt until its head comes off.



3. INSTALL STEERING COLUMN ASSEMBLY
(Click here).