EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS |
Inspect the hoses and gaskets for scratches, cracks or air/oil leaks from the connecting parts.
| 2. INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM |
Connect the Techstream to the DLC3.
![]() |
Disconnect the fuel vapor feed hose from the vacuum switching valve assembly shown in the illustration.
Put the engine in inspection mode (Click here).
Start the engine.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.
Check that vacuum occurs at the purge VSV port.
If vacuum does not occur, check the following items.
Exit Active Test mode and reconnect the fuel vapor feed hose.
Enter the following menus: Powertrain / Engine and ECT / Data List / EVAP Purge VSV.
Warm up the engine and drive the vehicle.
Confirm that the purge valve opens.
If the result is not as specified, replace the purge VSV, wire harness or ECM.
| 3. CHECK FUEL TANK AND VENT LINE |
Disconnect the vent line tube from the charcoal canister assembly.
Connect a pressure gauge to the vent line tube.

| *1 | Fuel Tank Cap | *2 | Vent Line Tube |
| *3 | Pressure Gauge | - | - |
Apply 4 kPa (0.04 kgf/cm2, 0.6 psi) of pressure to the vent line of the fuel tank.
Check that the fuel tank pressure is maintained for some time, and does not decrease immediately.
When the fuel tank cap is removed, check that the pressure is released smoothly.
Reconnect the vent line tube to the charcoal canister assembly.
| 4. INSPECT AIR LINE |
![]() |
Disconnect the air line tube from the charcoal canister with bracket assembly.
| *a | Air |
Check that air flows freely into the air line.
If air does not flow freely into the air line, repair or replace the air line tube.
Reconnect the air line tube to the charcoal canister with bracket assembly.