DTC B2788 IG2 Signal Malfunction |
| DTC No. | Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B2788 | Mismatch between the steering lock ECU IG2 input from the LIN communication system and from the direct line (1-trip detection logic*). |
| No confirmation operation is necessary (monitoring is continuous). |
| Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
| The steering cannot be locked or unlocked. For this reason, the hybrid control system cannot be started. | - |
| DTC No. | Data List Item | Active Test Item |
| B2788 | - | - |

| 1.INSPECT STEERING LOCK ECU (POWER SOURCE MODE SIGNAL) |
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the G50 steering lock ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G50-1 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Steering Lock ECU (Steering Lock Actuator Assembly)) |
Reconnect the G50 steering lock ECU connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G50-6 (IG2) - G50-1 (GND) | Power switch on (IG) | 11 to 14 V |
| G50-6 (IG2) - G50-1 (GND) | Power switch off | Below 1 V |
| *a | Component with harness connected (Steering Lock ECU (Steering Lock Actuator Assembly)) |
|
| ||||
| OK | ||
| ||