REAR CRANKSHAFT OIL SEAL > REMOVAL |
| 1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY |
| 2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY |
![]() |
Using SST, hold the crankshaft damper sub-assembly.
![]() |
Remove the 6 bolts and transmission input damper assembly from the flywheel sub-assembly.
| 3. REMOVE FLYWHEEL SUB-ASSEMBLY |
![]() |
Using SST, hold the crankshaft damper sub-assembly.
![]() |
Remove the 6 bolts and flywheel sub-assembly.
| 4. REMOVE REAR ENGINE OIL SEAL |
![]() |
Using a knife, cut off the lip of the rear engine oil seal.
| *1 | Protective Tape |
| *a | Cut Position |
Using a screwdriver with its tip wrapped with tape, pry out the rear engine oil seal.