Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    42    Electronically Controlled Brake System Malfunction

DTC    45    Electronically Controlled Brake System Malfunction

for Preparation Click here


DESCRIPTION

These DTCs are stored if the ABS and/or VSC system detects a malfunction in the electronically controlled brake system.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
42
-
Malfunction in the electronically controlled brake system.
Electronically controlled brake system
45
-
Malfunction in the electronically controlled brake system.
Electronically controlled brake system

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake booster with master cylinder assembly), perform initialization and calibration of the linear solenoid valve (Click here).

1.CHECK ELECTRONICALLY CONTROLLED BRAKE SYSTEM
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to ON (READY).

  1. Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.

  1. Check if an electronically controlled brake system DTC is output (Click here).

    Result:

    Result
    Proceed to
    Electronically controlled brake system DTC is not output.
    A
    Electronically controlled brake system DTC is output.
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A


2.RECONFIRM DTC
  1. Turn the ignition switch off.

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to ON (READY).

  1. Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.

  1. Check if the same DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTCs 42 and 45 are not output.
    A
    DTCs 42 and/or 45 are output.
    B



B
REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)