ELECTRONICALLY CONTROLLED BRAKE SYSTEM > DTC CHECK / CLEAR |
| DTC CHECK/CLEAR (When Using the Techstream) |
Check for DTCs.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Read the DTCs following the prompts on the Techstream screen. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
Check the details of the DTCs (Click here).
Clear the DTCs.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
Press the DTC clear button.
| DTC CHECK/CLEAR (When not Using the Techstream) |
Check for DTCs.
![]() |
Using SST, connect terminals TC and CG of the DLC3.
| *a | Front view of DLC3 |
Turn the ignition switch to ON (IG).
Observe the blinking pattern of the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights in order to identify the DTC.
| Trouble Area | See Procedure |
| TC and CG terminal circuit |
Click here
|
| ABS warning light circuit (Remains on) |
Click here
|
| ABS warning light circuit (Does not come on) |
Click here
|
| Brake warning light / yellow (minor malfunction) circuit (Remains on) |
Click here
|
| Brake warning light / yellow (minor malfunction) circuit (Does not come on) |
Click here
|
| Slip indicator light circuit (Remains on) |
Click here
|
| Slip indicator light circuit (Does not come on) |
Click here
|
Count the number of blinks of the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights.
Check the details of the DTCs (Click here).
After completing the check, disconnect terminals TC and CG of the DLC3 to turn off the display.
If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.
Clear the DTCs.
![]() |
Using SST, connect terminals TC and CG of the DLC3.
| *a | Front view of DLC3 |
Turn the ignition switch to ON (IG).
Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
Check that the warning light indicates a normal system code.
Remove SST from the terminals of the DLC3.
| END OF DTC CHECK/CLEAR |
Turn the ignition switch to ON (IG).
Check that the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights go off when the ignition switch is turned to ON (READY).