Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

for Preparation Click here


INSPECTION PROCEDURE

NOTICE:
  1. Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast.
  2. After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

1.CHECK SATELLITE RADIO
  1. Check radio condition.

    Result:
    Result
    Proceed to
    Broadcast cannot be selected
    A
    Broadcast can be selected, but selection can not be memorized
    B



B
Go to step 2
A

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)  

2.CHECK SATELLITE RADIO
  1. Check the number of preset channels.

    OK:
    36 channels have already been preset.



NG
Go to step 3
OK

END (ONLY 36 CHANNELS CAN BE PRESET) 

3.CHECK AUXILIARY BATTERY
  1. Check if the auxiliary battery was replaced.

    OK:
    Auxiliary battery was not replaced.



NG
Go to step 4
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)  

4.ADD PRESET CHANNEL INTO MEMORY AGAIN
  1. Check if the preset channels that have been cleared can be added into memory again.

    OK:
    Preset channels can be added into memory.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END