DTC B2785 Communication Malfunction between ECUs Connected by LIN |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2785 |
|
|

| 1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - EACH ECU) |
Disconnect the G54, G58, G49 and G50 connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G54-12 (LIN) - G50-5 (LIN) | Always | Below 1 Ω |
| G54-12 (LIN) - G58-11 (LIN2) | Always | Below 1 Ω |
| G54-12 (LIN) - G49-2 (LIN1) | Always | Below 1 Ω |
| G54-12 (LIN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK DTC OUTPUT (STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY)) |
Reconnect the G54, G58 and G49 connectors.
Clear the DTC (Click here).
Recheck for DTCs.
| Result | Proceed to |
| DTC B2785 is output | A |
| DTC B2785 is not output | B |
|
| ||||
| A | |
| 3.CHECK DTC OUTPUT (POWER MANAGEMENT CONTROL ECU) |
Reconnect the G50 connector.
Disconnect the G58 connector.
Clear the DTC (Click here).
Recheck for DTCs.
| Result | Proceed to |
| DTC B2785 is output | A |
| DTC B2785 is not output | B |
|
| ||||
| A | |
| 4.CHECK DTC OUTPUT (ID CODE BOX (IMMOBILISER CODE ECU)) |
Reconnect the G58 connector.
Disconnect the G49 connector.
Clear the DTC (Click here).
Recheck for DTCs.
| Result | Proceed to |
| DTC B2785 is output | A |
| DTC B2785 is not output | B |
|
| ||||
| A | ||
| ||