Home › Engine / Hybrid System › 1NZ-FXE FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
  1. Apply gasoline to 2 new O-rings and then install them to the fuel pressure regulator assembly.

  1. Install the fuel pressure regulator assembly.



2. INSTALL FUEL PUMP WITH FILTER ASSEMBLY


    A288172E01
  1. Apply gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump with filter assembly.
    Text in Illustration 
    *1
    O-ring
    *2
    Fuel Pump Spacer

  1. Connect the fuel pump harness connector.

  1. Engage the 5 claws of the fuel pump with filter assembly.

    NOTICE:
    1. Make sure that the O-ring is not cut or pinched during installation.
    2. Engage the claws securely.
    3. Do not remove the suction filter.

    HINT:
    Perform "Inspection After Repair" after replacing the fuel pump assembly (Click here).

  1. Engage the 2 claws to install the No. 1 fuel suction support.

  1. Engage the 2 claws of the No. 1 fuel suction support and install the fuel filter and the fuel pump with filter assembly onto the No. 1 fuel sub-tank.



    A265015
  1. Align the groove of the suction filter hose with the cutout of the No. 1 fuel sub-tank and install the hose.

    NOTICE:
    Do not apply excessive force to the fuel tube or the fuel suction plate.

  1. Connect the connector of the fuel pump harness.



3. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A309800
  1. Install the fuel sender gauge assembly by sliding it downward.

    NOTICE:
    Make sure that the fuel sender gauge arm does not bend.

  1. Connect the fuel sender gauge assembly connector.



4. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
(Click here)