Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here



1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(Click here).


2. REMOVE INNER COWL TOP TO COWL BRACE


    C250011
  1. Remove the 3 bolts and inner cowl top to cowl brace.



3. REMOVE FRONT AIR SHUTTER SEAL


    C250012
  1. Disengage the clamp to remove the front air shutter seal.



4. REMOVE FRONT NO. 1 VENTILATOR SEAL


    C250013
  1. Disengage the clamp to remove the front No. 1 ventilator seal.



5. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY


    C250014
  1. Disengage the clamp to separate the wire harness from the outer cowl top panel sub-assembly.



    C250015
  1. Remove the 8 bolts, nut and outer cowl top panel sub-assembly.



6. REMOVE AIR FUEL RATIO SENSOR


    A267409
  1. Disconnect the air fuel ratio sensor connector and 2 clamps.



    A267410E01
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010