Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR


    A267865E01
  1. Using SST, install the heated oxygen sensor onto the front exhaust pipe.
    Text in Illustration 
    *a
    Fulcrum Length
    30 mm (1.18 in.)
    *b
    Fulcrum Length
    260 mm (10.2 in.)

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 260 mm (10.2 in.) (Click here).
    2. The "with SST" torque value is effective when SST is parallel to the torque wrench.

    HINT:
    Perform "Inspection After Repair" after replacing the heated oxygen sensor (Click here).



2. INSTALL EXHAUST MANIFOLD
Click here