Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK CONTROL SENSOR


    A267412E01
  1. Install the knock control sensor with the bolt as shown in the illustration.
    Text in Illustration 
    *a
    Front of Engine
    *b
    10°
    *c
    30°

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    NOTICE:
    Make sure that the knock control sensor is in the correct position.

    HINT:
    Perform "Inspection After Repair" after replacing the knock control sensor (Click here).

  1. Connect the knock control sensor connector.



2. INSTALL INTAKE MANIFOLD
(Click here)