Home › Steering › STEERING COLUMN › STEERING WHEEL

STEERING WHEEL > INSTALLATION

for Preparation Click here


NOTICE:
  1. Do not replace the spiral cable with sensor sub-assembly with the negative (-) auxiliary battery cable connected and the ignition switch on (IG).
  2. Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the negative (-) auxiliary battery cable connected and the ignition switch on (IG).
  3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
  4. Do not remove the steering sensor from the spiral cable.



1. INSTALL LOWER STEERING WHEEL BOSS COVER


    C206252
  1. Engage the 2 pins and 4 claws to install the lower steering wheel boss cover to the steering wheel sub-assembly.



2. INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)


3. INSTALL CRUISE CONTROL SWITCH (w/ Cruise Control System)
  1. Install the cruise control switch with the 2 screws.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. Connect the connector.



4. INSTALL STEERING PAD SWITCH ASSEMBLY
  1. Engage the 2 claws to install the steering pad switch assembly (RH side) to the steering wheel sub-assembly.

  1. Install the 2 screws.

    Torque:
    2.4 N*m{ 25 kgf*cm , 21 in.*lbf }

  1. Engage the 2 claws to install the steering pad switch assembly (LH side) to the steering wheel sub-assembly.

  1. Install the 2 screws.

    Torque:
    2.4 N*m{ 25 kgf*cm , 21 in.*lbf }

  1. Connect the steering pad switch connector to the spiral cable.



5. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD


6. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B296308
  1. Rotate the spiral cable with sensor sub-assembly counterclockwise slowly by hand until it stops.

    NOTICE:
    Do not turn the spiral cable using the airbag wire harness.



    B296309E01
  1. Rotate the spiral cable with sensor sub-assembly clockwise approximately 2.5 turns to align the marks.
    Text in Illustration 
    *a
    Alignment Mark

    NOTICE:
    Do not turn the spiral cable using the airbag wire harness.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.



7. INSTALL STEERING WHEEL ASSEMBLY


    C252595E01
  1. Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.
    Text in Illustration 
    *a
    Matchmark

  1. Install the steering wheel assembly set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect the connectors to the spiral cable sub-assembly.



8. CHECK STEERING WHEEL CENTER POINT


9. INSTALL HORN BUTTON ASSEMBLY
(Click here)