Home › Steering › STEERING COLUMN › STEERING PAD SWITCH

STEERING PAD SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STEERING PAD SWITCH LH
  1. Connect the connector to install the steering pad switch LH to the steering pad switch RH.



    C258056E01
  1. Align a new clamp with the groove and install it as shown in the illustration.
    Text in Illustration 
    *1
    Clamp
    *a
    70 to 85 mm (2.76 to 3.35 in.)
    *b
    10 mm (0.394 in.) or less
    *c
    1 to 3 mm (0.0394 to 0.118 in.)
    V100135
    Front of the Vehicle

    NOTICE:
    Make sure to install the clamp in the correct direction.

  1. After installation, cut off the excess length of the clamp within the specified range *c shown in the illustration.



2. INSTALL STEERING PAD SWITCH ASSEMBLY
  1. Engage the 2 claws to install the steering pad switch assembly (RH side) to the steering wheel sub-assembly.

  1. Install the 2 screws.

    Torque:
    2.4 N*m{ 25 kgf*cm , 21 in.*lbf }

  1. Engage the 2 claws to install the steering pad switch assembly (LH side) to the steering wheel sub-assembly.

  1. Install the 2 screws.

    Torque:
    2.4 N*m{ 25 kgf*cm , 21 in.*lbf }

  1. Connect the steering pad switch connector to the spiral cable.



3. INSTALL HORN BUTTON ASSEMBLY
(Click here)