Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD

RADIO ANTENNA CORD > REMOVAL

for Preparation Click here



1. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY
(Click here)


2. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)


    E244891
  1. Remove the 4 screws.



    E244892
  1. Disengage the 2 guides and pull the radio receiver assembly with bracket toward the rear of the vehicle.

  1. Disconnect each connector and remove the radio receiver assembly with bracket.



3. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)


    E237149
  1. Remove the 4 screws.



    E237150
  1. Disengage the 2 guides and pull the radio and display receiver assembly with bracket toward the rear of the vehicle.

  1. Disconnect each connector and remove the radio and display receiver assembly with bracket.



4. REMOVE NO. 6 HEATER TO REGISTER DUCT ASSEMBLY


    B307673
  1. Disengage the clamp.



    B307674
  1. Disengage the 2 claws as shown in the illustration.



    B307676
  1. Disengage the guide and remove the No. 6 heater to register duct assembly as shown in the illustration.



5. REMOVE ANTENNA CORD SUB-ASSEMBLY
  1. Disconnect each connector.



  1. Remove the 2 bolts.


    E237158

  1. Disengage the 5 clamps and remove the antenna cord sub-assembly.



6. REMOVE ROOF HEADLINING ASSEMBLY
(Click here)


7. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
  1. Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.

    HINT:
    Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.



  1. Disengage each clamp and remove the No. 2 antenna cord sub-assembly from the roof headlining.


    E237161E01


    Text in Illustration 
    *A
    w/o Sliding Roof
    *B
    w/ Sliding Roof
    *1
    Tape
    -
    -
    *a
    Front
    -
    -