DTC B27A7 Open in Inside Luggage Compartment Electrical Key Oscillator Circuit |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B27A7 | An open circuit is detected in the circuit between the certification ECU (smart key ECU assembly) and No. 3 indoor electrical key antenna assembly (rear floor) (CLG7 - ANTE7, CG7B - CLGB) (1 trip detection logic*). |
| Any time |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
When electrical key transmitter sub-assembly is in rear seat area:
| - |
| DTC Code | Data List and Active Test |
| B27A7 | Key diagnostic mode can be used to perform troubleshooting |

| 1.CHECK CONNECTOR CONNECTION |
Turn the power switch off.
Check that the connectors are properly connected to the certification ECU (smart key ECU assembly) and No. 3 indoor electrical key antenna assembly (rear floor).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY) |
Disconnect the G53 and G55 certification ECU (smart key ECU assembly) connectors.
Disconnect the M16 No. 3 indoor electrical key antenna assembly (rear floor) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G53-4 (CLG7) - M16-1 (ANTE7) | Always | Below 1 Ω |
| G53-3 (CG7B) - M16-3 (CLGB) | Always | Below 1 Ω |
| G55-1 (E) - Body ground | Always | Below 1 Ω |
| G53-4 (CLG7) or M16-1 (ANTE7) - Body ground | Always | 10 kΩ or higher |
| G53-3 (CG7B) or M16-3 (CLGB) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (OUTPUT TO NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY) |
Connect the G53 and G55 certification ECU (smart key ECU assembly) connectors.

| *1 | Waveform | - | - |
| *a | Component with harness connected (Certification ECU (smart key ECU assembly)) | *b | Before driver door lock sensor touched |
| *c | After driver door lock sensor touched | - | - |
Connect the M16 No. 3 indoor electrical key antenna assembly (rear floor) connector.
Using an oscilloscope, check the waveform.
| Tester Connection | Switch Condition | Tool Setting | Specified Condition |
| G53-4 (CLG7) - G55-1 (E) | Proceed:
| 2 V/DIV., 500 ms/DIV. | Pulse generation (See waveform) |
| G53-3 (CG7B) - G55-1 (E) | Proceed:
| 2 V/DIV., 500 ms/DIV. | Pulse generation (See waveform) |
|
| ||||
| OK | |
| 4.REPLACE NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (REAR FLOOR) |
Temporarily replace the No. 3 indoor electrical key antenna assembly (rear floor) with a new or known good one (Click here).
| NEXT | |
| 5.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 6.CHECK FOR DTC |
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||