Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY

CENTER AIRBAG SENSOR ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL AIRBAG SENSOR ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



  1. Using SST, install the airbag sensor assembly with the 3 bolts.


    B300243E01


    Text in Illustration 
    *a
    Fulcrum Length
    -
    -
    SST
    09961-00950  

    Torque:
    without SST:
    18 N*m{ 178 kgf*cm , 13 ft.*lbf }
    with SST:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }

    NOTICE:
    1. Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
    2. This torque value is effective when SST is parallel to a torque wrench.
    3. If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
    4. When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
    5. When the ignition switch is first turned on (IG) after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.



    B296227E01
  1. Connect the connectors to the airbag sensor assembly as shown in the illustration.

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.

  1. Check that the waterproof sheet is properly set.
    Text in Illustration 
    *1
    Waterproof Sheet

  1. Check that there is no looseness in the installation parts of the airbag sensor assembly.

  1. Connect the air conditioning amplifier assembly connector.



2. INSTALL REAR CONSOLE BOX ASSEMBLY
(Click here)


3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. INSTALL FRONT FLOOR COVER RH
  1. Engage the 3 guides.



    B301488E01
  1. Engage the 3 clips <B> to install the front floor cover RH.

  1. Install the 2 clips <A>.



5. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)


6. INSPECT SRS WARNING LIGHT
(Click here)


7. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

HINT:
  1. When the airbag sensor assembly is replaced, perform zero point learning for the yaw rate and acceleration sensor (Click here).
  2. The yaw rate and acceleration sensor is built into the airbag sensor assembly.