BRAKE FLUID > BLEEDING |
| Replaced/Installed Item | Work Procedure |
| Flexible hose (front/rear) | Bleed brake line |
| Front disc brake cylinder assembly | |
| Rear wheel cylinder assembly | |
| Brake booster pump assembly | Bleed brake system |
| Brake booster with master cylinder assembly | |
| Brake master cylinder reservoir assembly |
| 1. BLEED BRAKE LINE |
![]() |
Disengage the 4 claws and 6 guides, and separate the center No. 1 cowl top ventilator louver.
Bleed brake line.
![]() |
Remove the brake master cylinder reservoir filler cap assembly.
Add brake fluid into the reservoir between the MAX and MIN lines on the brake fluid reservoir.
Connect the Techstream to the DLC3 and turn the ignition switch to ON (IG).
Turn the Techstream on and enter the following menus: Chassis / ABS/VSC/TRAC / Air Bleeding.
Select "Usual air bleeding" on the Techstream display, and bleed air from the brake fluid following the instructions on the Techstream.
After air bleeding, tighten each bleeder plug.
Clear the DTCs (Click here).
Turn the Techstream off and turn the ignition switch off.
Install the brake master cylinder reservoir filler cap.
Inspect for brake fluid leaks.
Engage the 4 claws and 6 guides to install the center No. 1 cowl top ventilator louver.
| 2. BLEED BRAKE SYSTEM |
Remove the outer cowl top panel sub-assembly .
Bleed the brake system.
![]() |
Wait at least 2 minutes with the ignition switch off, and disconnect the reservoir level switch connector.
![]() |
Remove the brake master cylinder reservoir filler cap assembly.
Add brake fluid into the reservoir between the MAX and MIN lines on the brake fluid reservoir.
Connect the Techstream to the DLC3 and turn the ignition switch to ON (IG).
Turn the Techstream on and enter the following menus: Chassis / ABS/VSC/TRAC / Air Bleeding.
Select "ABS actuator has been replaced" on the Techstream display, and bleed air from the brake fluid following the instructions on the Techstream.
![]() |
After air bleeding, tighten each bleeder plug.
| *1 | Stroke Simulator Bleeder Plug |
Clear the DTCs (Click here).
Turn the Techstream off and turn the ignition switch off.
Install the brake master cylinder reservoir filler cap.
Inspect for brake fluid leaks.
Install the outer cowl top panel sub-assembly .