DTC P106A Evaporative Emission System Pressure Sensor - Manifold Absolute Pressure Correlation |
| DTC No. | DTC Detection Condition | Trouble Area |
| P106A | The difference between the pressure of the canister pressure sensor (Vapor Pressure Pump*) and manifold absolute pressure sensor (MAP*) is higher than 8.7 kPa [65.259 mmHg] (2 trip detection logic). |
|
| Related DTCs | P106A: Absolute pressure sensor rationality |
| Required Sensors/Components (Main) | Canister pressure sensor Manifold absolute pressure sensor |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Once per driving cycle |
| Duration | Within 65 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not stored | P0106, P0107, P0108 (Manifold absolute pressure) P0401 (EGR system (closed)) P0452, P0453 (Evaporative emission system pressure sensor) |
| Time elapsed after engine stop | 50 minutes |
| Time after ECM started by soak-timer | 60 seconds or more |
| Auxiliary battery voltage | 10.5 V or higher |
| Intake air temperature | -10°C (14°F) or higher |
| Engine coolant temperature sensor | -10°C (14°F) or higher |
| Difference between EVAP pressure and manifold absolute pressure | Higher than 8.7 kPa [65.259 mmHg] |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P106A) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P106A is output | A |
| DTC P106A and other DTCs are output | B |
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM (VAPOR PRESSURE PUMP AND MAP) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / Vapor Pressure Pump and MAP.
Compare the Vapor Pressure Pump and MAP data from the Data List with day's atmospheric pressure*.
| Result | Proceed to |
| If the Vapor Pressure Pump value differs from the atmospheric pressure by 3.5 kPa [26.254 mmHg] or higher | A |
| If the MAP value differs from the atmospheric pressure by 3.5 kPa [26.254 mmHg] or higher | B |
|
| ||||
| A | |
| 3.REPLACE CANISTER PUMP MODULE |
Replace the canister pump module .
|
| ||||
| 4.REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR |
Replace the manifold absolute pressure sensor (Click here).
| NEXT | |
| 5.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG) and the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / Vapor Pressure Pump and MAP.
Confirm that the difference between Vapor Pressure Pump and MAP are 3.5 kPa [26.25 mmHg] or less.
| NEXT | ||
| ||