Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    C1257/57    Power Supply Drive Circuit

for Preparation Click here


DESCRIPTION

The skid control ECU detects a drop in accumulator pressure according to the signals from the accumulator pressure sensor, then operates and stops the motor relay as well as the pump motor.
The skid control ECU troubleshoots the built-in motor relay drive circuit, and stores this DTC when a malfunction is detected.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
C1257/57
361
While accumulator pressure falls below hard pump ON pressure, the hard drive circuit does not operate for 1 second or more.
Skid control ECU (Brake booster with master cylinder assembly)
↑
362
When hard driving, one of the 3 built-in motor relays does not operate for 0.2 seconds or more.
↑

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake booster with master cylinder assembly), perform initialization and calibration of the linear solenoid valve (Click here).

HINT:
When C1241/41, C1242/42 and/or C1253/53 are output together with C1257/57, inspect and repair the trouble areas indicated by C1241/41, C1242/42 and/or C1253/53 first (Click here or Click here).

1.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
  1. Replace the skid control ECU (brake booster with master cylinder assembly) (Click here).


NEXT

END