Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > PRECAUTION

for Preparation Click here



1.NOTICE FOR INITIALIZATION

NOTICE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system after the cable is reconnected.

System Name
See Procedure
Power Door Lock Control System
Click here


2.IGNITION SWITCH EXPRESSIONS
  1. The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression
    Ignition Switch (Position)
    Power Switch (Condition)
    Ignition Switch off
    LOCK
    Off (Lock)
    Ignition Switch ACC
    ACC
    On (ACC)
    Ignition Switch ON
    ON
    On (IG)
    READY ON
    READY
    On (READY)


3.CAN COMMUNICATION SYSTEM TROUBLESHOOTING
  1. Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output (Click here).


4.PRECAUTIONS FOR STEERING SYSTEM HANDLING
  1. Be careful when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazardous driving.


5.PRECAUTIONS FOR SRS AIRBAG SYSTEM HANDLING
  1. This vehicle is equipped with a Supplemental Restraint System (SRS) which includes parts such as airbags for the driver and front passenger. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may cause a serious accident. Before servicing (including removal or installation of parts, inspection or replacement), be sure to read Precaution for SRS (Click here).

    HINT:
    See Supplemental Restraint Systems.


6.BUS LINE REPAIR


    F045104
  1. After repairing a bus line with solder, wrap the repaired part with electrical tape.

    NOTICE:
    1. The CANL bus line and CANH bus line must be installed together at all times.
    2. When installing, make sure that these lines are twisted, because CAN bus lines are likely to be influenced by electrical noise if the bus lines are not twisted.
    3. Leave approximately 80 mm (3.15 in.) loose in the twisted wires around the connector.
    4. When repairing the CAN bus lines, do not change the length of the lines. (Make sure that the length of the CANH bus line and CANL bus line are the same.)



  2. F045105E17
  3. Do not use bypass wiring between connectors.
    Text in Illustration 
    *a
    Bypass Wire

    NOTICE:
    1. The ability of the twisted bus lines to resist interference will be lost if bypass wiring is used.
    2. Do not use a twisted pair of wires for bypass wiring.


7.CONNECTOR HANDLING


    F045106E10
  1. When checking resistance with a tester, insert the tester probes from the backside (harness side) of the connector.
    Text in Illustration 
    *a
    Tester Probe



  2. F045107E22
  3. Use service wires to check the connector if it is impossible to check continuity from the rear of the connector.
    Text in Illustration 
    *a
    Service Wire


8.PRECAUTIONS FOR INSPECTING OR REPLACING CAN JUNCTION CONNECTOR
  1. If the CAN junction connector is removed from the vehicle for inspection or replacement, make sure to install the CAN junction connector and all wire harnesses to their original locations with tape and the clamps.