ENGINE IMMOBILISER SYSTEM (w/o Smart Key System) > Key Cannot be Registered |
| 1.CHECK REGISTRATION MODE |
Check that the system enters registration mode.
|
| ||||
| OK | |
| 2.CHECK SECURITY INDICATOR LIGHT OPERATION |
In the registration mode, when the key inserted in ignition key cylinder, check that the security indicator light.

| Result | Proceed to |
| Code 2-1 | A |
| Code 2-2 | B |
| Code 2-3 | C |
|
| ||||
|
| ||||
| A | |
| 3.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Immobiliser / Data List.
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Transponder S-code | Number of registered sub-keys / min.: 0, max.: 15 | Number of registered sub-keys | - |
| Transponder M-code | Number of registered master keys / min.: 0, max.: 15 | Number of registered master keys | - |
| Result | Proceed to |
| None of the below | A |
| Registered master keys: 5, registered sub-keys: 0 | B |
| Registered master keys: 0, registered sub-keys: 3 | C |
| Registered master keys: 5, registered sub-keys: 3 | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 4.KEY REGISTRATION |
Refer to the table below to determine if additional keys can be registered.
| Number of Keys Registered (Master and Sub) | Proceed to |
| 0 | New key ID registration (Click here) |
| 1 to 7 | Additional key ID registration (Click here) |
Check if an additional key can be registered.
|
| ||||
| OK | ||
| ||
| 5.INSPECT UNLOCK WARNING SWITCH ASSEMBLY |
Inspect the unlock warning switch assembly (Click here).
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - UNLOCK WARNING SWITCH ASSEMBLY) |
Disconnect the G17 unlock warning switch assembly connector.
Disconnect the G46 transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G17-1 - G46-3 (KSW) | Always | Below 1 Ω |
| G17-2 - Body ground | Always | Below 1 Ω |
| G17-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||