Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART KEY SYSTEM (for Entry Function)

SMART KEY SYSTEM (for Entry Function) > All Door Entry Unlock Functions except Driver Door do not Operate

for Preparation Click here


DESCRIPTION

When the entry unlock function operates only for the driver door, one of the following may be the cause: 1) the customize setting has been changed, 2) a malfunction in the power door lock control system, 3) a malfunction in the certification ECU (smart key ECU assembly) or main body ECU (multiplex network body ECU).

INSPECTION PROCEDURE

NOTICE:
  1. The smart key system (for Entry Function) uses a multiplex communication system (LIN communication system) and the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (Click here). Troubleshoot the smart key system (for Entry Function) after confirming that the communication systems are functioning properly.
  2. When using the Techstream with the power switch off to troubleshoot:
    Connect the Techstream to the DLC3 and turn a courtesy light switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.
  3. Check that there are no electrical key transmitter sub-assemblies in the vehicle.
  4. Before performing the inspection, check that DTC B1242 (wireless door lock control) is not output (Click here).
  5. Before replacing the certification ECU (smart key ECU assembly), refer to the smart key system (for Entry Function) precaution (Click here).
  6. After repair, confirm that no DTCs are output by performing the "DTC Output Confirmation Operation".

1.CHECK CUSTOMIZE INFORMATION (DOOR UNLOCK MODE)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Customize Setting / Smart Key/Access.

  1. Check the customize setting.


Smart Key/Access 
Display
Default
Content
Setting
Relevant ECU
Door Unlock Mode2
Driver
Function that chooses the doors to be operated by entry unlock operation.
All or Driver
Certification ECU (smart key ECU assembly)

Result:
Result
Proceed to
"Driver" is selected.
A
"ALL" is selected.
B



B
Go to step 4
A


2.CHANGE CUSTOMIZE SETTING
  1. Select "All" for the customize setting.

Result:
Result
Proceed to
"All" can be selected.
A
"All" cannot be selected.
B



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)
OK


3.CHECK SMART KEY SYSTEM (ENTRY UNLOCK OPERATION)
  1. Check that the entry unlock functions operate normally (Click here).

OK:
Entry unlock functions operate normally.



NG
Go to step 4
OK

END (DIFFERENT CUSTOMIZE SETTING ITEM WAS SELECTED) 

4.CHECK POWER DOOR LOCK CONTROL SYSTEM
  1. Check if the power door lock control system operates properly for doors other than the driver door (Click here).

HINT:
Make sure to check doors one by one.



NG
GO TO POWER DOOR LOCK CONTROL SYSTEM (Click here)
OK


5.REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
  1. Temporarily replace the certification ECU (smart key ECU assembly) with a new one.

HINT:
  1. For replacement, (Click here).
  2. For registration, (Click here).


NEXT


6.CHECK SMART KEY SYSTEM (ENTRY UNLOCK OPERATION)
  1. Check that the entry unlock functions operate normally (Click here).

OK:
Entry unlock functions operate normally.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

END (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) WAS DEFECTIVE)