CHARGING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CONFIRM PROBLEM SYMPTOMS |
| |||||
| 3.CUSTOMER PROBLEM ANALYSIS |
Check if the vehicle has been jump started due to a discharged auxiliary battery.
| Result | Proceed to |
| The vehicle has never been jump started. | A |
| The vehicle has been jump started due to a discharged auxiliary battery. | B |
|
| ||||
| |||||
| 4.CAN COMMUNICATION SYSTEM CHECK |
Using the Techstream, display the CAN Bus Check screen and check that all ECUs and sensors that are connected to CAN communication system are displayed on the screen.
|
| ||||
| |||||
| 5.CHECK FOR DTCS |
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| |||||
| 6.ON-VEHICLE INSPECTION |
| Result | Proceed to |
| Malfunctioning area has been determined | A |
| Malfunctioning area has not been determined | B |
|
| ||||
| |||||
| 7.CHECK FOR INTERMITTENT PROBLEMS |
| |||||
| 8.REPAIR OR REPLACE |
|
| ||||
|---|---|---|---|---|---|