Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM

DTC    C1645    Power Steering Control System Failure

for Preparation Click here


DESCRIPTION

This DTC is stored when the parking assist ECU receives a malfunction signal from the power steering system via CAN communication.

DTC No.
DTC Detection Condition
Trouble Area
C1645
Power steering system malfunction judgment
Power steering system

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTCs are not output
    A
    DTC C1645 is output
    (for Brushless Type Motor)
    B

    HINT:
    1. The DTC is stored when a malfunction occurs in the power steering system.
    2. This DTC may be output due to a temporary phenomenon such as low voltage or EPS overheat protection.
    3. If troubleshooting and repair of a malfunction in the power steering system has been completed, DTC C1645 will not be output again when rechecking for DTCs.
    4. If DTC C1645 is output frequently, duplicate the problem symptoms and perform the inspection again, even though the DTCs are not output when rechecking for DTCs (Click here).



B
GO TO POWER STEERING SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)