DTC P0037 Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) |
DTC P0038 Oxygen Sensor Heater Control Circuit High (Bank 1 Sensor 2) |
DTC P102D O2 Sensor Heater Circuit Performance Bank 1 Sensor 2 Stuck ON |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0037 | The heater current less than the specified value while the heater is operating (1 trip detection logic). |
|
| P0038 | The heater current is higher than the specified value while the heater is operating (1 trip detection logic). |
|
| P102D | The heater current is higher than the specified value while the heater is not operating (1 trip detection logic). | ECM |
| 1.INSPECT HEATED OXYGEN SENSOR (HEATER RESISTANCE) |
![]() |
Disconnect the heated oxygen sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 (HT1B) - 2 (+B) | 20°C (68°F) | 11 to 16 Ω |
| 1 (HT1B) - 4 (E2) | Always | 10 kΩ or higher |
| *1 | Component without harness connected (Heated Oxygen Sensor (Sensor 2)) |
Reconnect the heated oxygen sensor connector.
|
| ||||
| OK | |
| 2.CHECK TERMINAL VOLTAGE (POWER SOURCE) |
![]() |
Disconnect the heated oxygen sensor connector.
Turn the power switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D9-2 (+B) - Body ground | Power switch on (IG) | 11 to 14 V |
| *1 | Front view of harness connector ( to Heated Oxygen Sensor (Sensor 2)) |
Reconnect the heated oxygen sensor connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (HEATED OXYGEN SENSOR - ECM) |
Disconnect the heated oxygen sensor connector.

Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D9-1 (HT1B) - D28-41 (HT1B) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| D9-1 (HT1B) or D28-41 (HT1B) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of harness connector (to Heated Oxygen Sensor (Sensor 2)) | *2 | Front view of harness connector (to ECM) |
Reconnect the heated oxygen sensor connector.
Reconnect the ECM connector.
|
| ||||
| OK | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (DTC P0037, P0038 OR P102D) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Clear the DTCs (Click here).
Put the engine in inspection mode (Click here).
Start the engine and idle for 5 minutes or more.
With the vehicle stationary, depress the accelerator pedal and maintain an engine speed of 2500 rpm for 1 minute.
Idle the engine for 5 minutes or more.
Enter the following menus: Powertrain / Engine and ECT / DTC / Pending.
Read the pending DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P0037, P0038 or P102D is output | B |
|
| ||||
| A | ||
| ||