DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2102 | Both of the following conditions continue for 2 seconds (1 trip detection logic): (a) Throttle actuator duty ratio is 80% or more (b) Throttle actuator current is below 0.5 A |
|
| P2103 | Either condition is met (1 trip detection logic):
|
|

| 1.INSPECT THROTTLE BODY ASSEMBLY (RESISTANCE OF THROTTLE ACTUATOR) |
![]() |
Disconnect the throttle body assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2 (M+) - 1 (M-) | 20°C (68°F) | 0.3 to 100 Ω |
| *1 | Component without harness connected (Throttle Body Assembly) |
Reconnect the throttle body assembly connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE BODY ASSEMBLY - ECM) |
Disconnect the throttle body assembly connector.

Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D4-2 (M+) - D28-21 (M+) | Always | Below 1 Ω |
| D4-1 (M-) - D28-20 (M-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| D4-2 (M+) or D28-21 (M+) - Body ground | Always | 10 kΩ or higher |
| D4-1 (M-) or D28-20 (M-) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Throttle Body Assembly) | *2 | Front view of wire harness connector (to ECM) |
Reconnect the ECM connector.
Reconnect the throttle body assembly connector.
|
| ||||
| OK | |
| 3.INSPECT THROTTLE BODY ASSEMBLY (VISUALLY CHECK THROTTLE VALVE) |
Check for foreign objects between the throttle valve and the housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE BODY ASSEMBLY (THROTTLE VALVE) |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||