Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use the following procedure to troubleshoot the audio and visual system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT


    3.PROBLEM SYMPTOMS TABLE

      HINT:
      Refer to Problem Symptoms Table (Click here).


      Result:

      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B



    B.
    Go to step 5
    A


    4.OVERALL ANALYSIS AND TROUBLESHOOTING

      HINT:
      Refer to Terminals of ECU (Click here).


    NEXT


    5.ADJUST, REPAIR OR REPLACE

      NEXT


      6.CONFIRMATION TEST

        NEXT

        END