NAVIGATION SYSTEM (for HDD) > Voice Recognition Difficulty |
| 1.CHECK CONDITION |
Check if the system voice recognition level is low when recognizing a particular voice.
| Result | Proceed to |
| System voice recognition level is low with any voice. | A |
| System voice recognition level is low only for a particular voice. | B |
|
| ||||
| A | |
| 2.CHECK HARD DISK DRIVE (OPERATION CHECK) |
![]() |
Enter the "Failure Diagnosis" screen. Refer to Check Hard Disk Drive in Operation Check (Click here).
Select "HDD Check" and check the result.
| *1 | Result |
|
| ||||
| OK | |
| 3.CHECK CABIN |
Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.
|
| ||||
| OK | |
| 4.CHECK MICROPHONE AND VOICE RECOGNITION (OPERATION CHECK) |
![]() |
Enter the "Microphone & Voice Recognition Check" screen. Refer to Check Mic & Voice Recognition in Operation Check (Click here).
When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.
Push the recording switch and perform voice recording.
Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.
| *1 | Microphone Input Level Meter |
| *2 | Recording Switch |
| *3 | Stop Switch |
| *4 | Play Switch |
| *5 | Recording Indicator |
|
| ||||
| OK | ||
| ||