Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for HDD)

NAVIGATION SYSTEM (for HDD) > Vehicle Position Mark is not Updated

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK OPERATION CHECK


    E181026E02
  1. Enter the "Failure Diagnosis" screen. Refer to Check Hard Disk Drive in Operation Check (Click here).

  1. Select "HDD Check" and check the result.

    OK:
    "OK" is displayed.

    HINT:
    After "HDD Check" is selected, it may take a while until the result is displayed.

Text in Illustration 
*1
Result


NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2.CHECK CABIN
  1. Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

    HINT:
    1. A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
    2. The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

    OK:
    Condensation is not likely being produced and the temperature is not high or extremely low.



NG
SET CABIN TO APPROPRIATE TEMPERATURE
OK


3.CHECK VEHICLE SENSOR (OPERATION CHECK)


    E176549
  1. Enter the "Vehicle Sensors" screen. Refer to Check GPS & Vehicle Sensors in Operation Check (Click here).

  1. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.

    OK:
    The readings are almost equal.



NG
CHECK DTC OUTPUT (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)