Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for HDD)

NAVIGATION SYSTEM (for HDD) > Vehicle Position Mark Deviates Greatly

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK GPS MARK


    E181043E03
  1. Check that the GPS mark is displayed.

    OK:
    GPS mark is displayed.

Text in Illustration 
*1
Example


NG
GO TO "GPS MARK IS NOT DISPLAYED" IN PROBLEM SYMPTOMS TABLE (Click here)
OK


2.CHECK VEHICLE SENSOR (OPERATION CHECK)


    E176549
  1. Enter the "Vehicle Sensors" screen. Refer to Check GPS & Vehicle Sensors in Operation Check (Click here).

  1. While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check that these readings are almost equal.

    OK:
    The readings are almost equal.



NG
CHECK DTC OUTPUT (Click here)
OK


3.CHECK VEHICLE SIGNAL (OPERATION CHECK)
  1. Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (Click here).



    E176550
  1. Check that the display changes between ON and OFF according to the shift lever operation.

    OK:
    Shift Lever Position
    Display
    Except R
    OFF
    R
    ON

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
GO TO "REVERSE SIGNAL DOES NOT CHANGE IN NAVIGATION CHECK MODE" IN PROBLEM SYMPTOMS TABLE (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)