Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM

DTC    B278A    Short to GND in Immobiliser System Power Source Circuit

for Preparation Click here


DESCRIPTION

This DTC is stored when the power switch power source supply line is open or shorted.

DTC No.
DTC Detection Condition
Trouble Area
B278A
Power switch power source supply line is open or shorted.
  1. Wire harness or connector
  2. Power switch
  3. Certification ECU (Smart key ECU assembly)

WIRING DIAGRAM


B219132E15


INSPECTION PROCEDURE

NOTICE:
  1. If the certification ECU (smart key ECU assembly) is replaced, register all the keys and ECU communication ID.*1
  2. If the certification ECU (smart key ECU assembly) is replaced, register all the keys.*2
    1. *1: w/o Airbag Cut-off Switch
    2. *2: w/ Airbag Cut-off Switch

1.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs (Click here).

    OK:
    DTC B278A is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER SWITCH)
  1. Disconnect the certification ECU (smart key ECU assembly) connector.



    B203502E08
  1. Disconnect the power switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L62-28 (VC5) - L43-14 (VC5)
    Always
    Below 1 Ω
    L62-36 (AGND) - L43-8 (AGND)
    Always
    Below 1 Ω
    L62-28 (VC5) - Body ground
    Always
    10 kΩ or higher
    L62-36 (AGND) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Certification ECU (Smart Key ECU Assembly))
    *2
    Front view of wire harness connector
    (to Power Switch)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
  1. Reconnect the certification ECU (smart key ECU assembly) connector.

  1. Reconnect the power switch connector.



    B219463E03
  1. Using an oscilloscope, check the waveform.

    Waveform (Reference):
    Item
    Content
    Tester Connection
    L43-14 (VC5) - L43-8 (AGND)
    Tool Setting
    2 V/DIV., 200 ms./DIV.
    Condition
    1. Power switch off
    2. Key not in cabin
    3. Power switch pressed within 30 seconds

    OK:
    Waveform is output normally (see illustration)

    Text in Illustration 
    *1
    Component with harness connected
    (Power Switch)
    *2
    GND



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

REPLACE POWER SWITCH (Click here)