DTC B278A Short to GND in Immobiliser System Power Source Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| B278A | Power switch power source supply line is open or shorted. |
|

| 1.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER SWITCH) |
Disconnect the certification ECU (smart key ECU assembly) connector.
![]() |
Disconnect the power switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L62-28 (VC5) - L43-14 (VC5) | Always | Below 1 Ω |
| L62-36 (AGND) - L43-8 (AGND) | Always | Below 1 Ω |
| L62-28 (VC5) - Body ground | Always | 10 kΩ or higher |
| L62-36 (AGND) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly)) |
| *2 | Front view of wire harness connector (to Power Switch) |
|
| ||||
| OK | |
| 3.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Reconnect the certification ECU (smart key ECU assembly) connector.
Reconnect the power switch connector.
![]() |
Using an oscilloscope, check the waveform.
| Item | Content |
| Tester Connection | L43-14 (VC5) - L43-8 (AGND) |
| Tool Setting | 2 V/DIV., 200 ms./DIV. |
| Condition |
|
| *1 | Component with harness connected (Power Switch) |
| *2 | GND |
|
| ||||
| OK | ||
| ||