Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > Headlight Signal Circuit

for Preparation Click here


DESCRIPTION

The headlight cleaner control relay detects the low beam headlights status.

WIRING DIAGRAM


E250817E03


INSPECTION PROCEDURE

NOTICE:
First check that the low beam headlights operate normally.

1.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY)
  1. Disconnect the A44 headlight cleaner control relay connector.

  1. Disconnect the 2C instrument panel junction block assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A44-1 (HDLO) - 2C-35
    Always
    Below 1 Ω
    A44-1 (HDLO) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    E182506E49
  1. Remove the instrument panel junction block assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2C-35 - MB-25 (HDLO)
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Component without harness connected
    (Instrument Panel Junction Block Assembly)



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)