MAIN BODY ECU > REMOVAL |
| 1. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY |
| 2. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY |
| 3. REMOVE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (for LHD) |
![]() |
Disengage the clamp and disconnect the wire harness.
Disconnect the 3 connectors (1), (2) and (3).
Disengage the 2 claws and disconnect the 2 connectors (4) and (5) as shown in the illustration.
![]() |
Remove the bolt and nut, and disconnect the driver side junction block assembly.
![]() |
Disengage the 6 claws and remove the junction block bracket.
![]() |
Disengage the 2 clamps and disconnect the wire harness.
![]() |
Disengage the claw and disconnect the connector as shown in the illustration.
![]() |
Disengage the claw and release the connector lock as shown in the illustration.
![]() |
Disengage the claw and disconnect the connector as shown in the illustration.
Remove the driver side junction block assembly.
| 4. REMOVE ECU INTEGRATION BOX (for RHD) |
Disconnect each connector.
![]() |
Disengage the clamp and disconnect the wire harness.
Remove the bolt, nut and ECU integration box.
| 5. REMOVE FRONT PASSENGER SIDE JUNCTION BLOCK ASSEMBLY (for RHD) |
![]() |
Disconnect the connector (1).
Disengage the 2 claws and disconnect the connector (2) and (3) as shown in the illustration.
![]() |
Disengage the 2 clamps and disconnect the wire harness.
Remove the bolt and nut, and disconnect the front passenger side junction block assembly.
![]() |
Disengage the clamp and disconnect the wire harness.
Disengage the claw and disconnect the connector as shown in the illustration.
![]() |
Disengage the claw and release the connector lock as shown in the illustration.
![]() |
Disengage the claw and disconnect the connector as shown in the illustration.
Remove the front passenger side junction block assembly.
| 6. REMOVE MAIN BODY ECU |
![]() |
Press the claw of the junction block as shown in the illustration to release the lock.
| *1 | Main Body ECU |
| *2 | Driver Side Junction Block |
| *3 | Protective Tape |
With the junction block lock released, insert a screwdriver with its tip taped horizontally between the main body ECU and junction block.
![]() |
Using the screwdriver, carefully raise the main body ECU up to the position where the connector becomes disengaged.
![]() |
Raise the main body ECU as shown by arrow (1), and then pull it out as shown by arrow (2) in the illustration.