FRONT PASSENGER AIRBAG ASSEMBLY > DISPOSAL |
| 1. PRECAUTION |
| 2. DISPOSE OF FRONT PASSENGER AIRBAG ASSEMBLY (When Installed in Vehicle) |
![]() |
Check the function of SST .
Refer to Precaution (Click here).
Disconnect the cable from the negative (-) battery terminal.
Remove the grove compartment door .
Disconnect the No. 3 instrument panel wire.
![]() |
Slide the slider to release the lock, and then disconnect the connector.
| *1 | Slider |
Install SST.
![]() |
Connect the SST connector to the No. 3 instrument panel wire.
![]() |
Move SST at least 10 m (32.8 ft.) away from the front side window of the vehicle.
| *1 | Battery |
Maintaining sufficient clearance for the SST wire harness in the front side window, close all doors and windows of the vehicle.
Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (32.8 ft.) radius of the vehicle.
Press the SST activation switch and deploy the airbag.
| 3. DISPOSE OF FRONT PASSENGER AIRBAG ASSEMBLY (When Not Installed in Vehicle) |
![]() |
Check the function of SST .
Remove the front passenger airbag assembly (Click here).
Install SST.
![]() |
After connecting the following SST to each other, connect them to the front passenger airbag assembly.
![]() |
Using braided wire, tie down the front passenger airbag assembly to an unneeded tire.
| *1 | Stripped Wire Section |
| *2 | Wire Diameter |
Position the front passenger airbag assembly inside the tire with the airbag deployment side facing inside.

| *1 | Inner Diameter | *2 | Width |
![]() |
Place the tires.
Place at least 2 tires under the tire to which the front passenger airbag assembly is tied.
Place at least 2 tires onto the tire to which the front passenger airbag assembly is tied. The top tire should have a wheel installed.
![]() |
Tie the tires together with the 2 wires.
Install SST.
![]() |
Connect the SST connector.
| *1 | Front Passenger Airbag Assembly |
| *2 | Battery |
Move SST at least 10 m (32.8 ft.) away from the airbag tied down to the tire.
Deploy the airbag.
Connect the red clip of SST to the positive (+) battery terminal and the black clip of SST to the negative (-) battery terminal.
Check that no one is within a 10 m (32.8 ft.) radius of the tire to which the front passenger airbag assembly is tied.
Press the SST activation switch and deploy the airbag.
![]() |
Dispose of the front passenger airbag assembly.
Remove the front passenger airbag assembly from the tire.
Place the front passenger airbag assembly in a plastic bag, tie it tightly, and dispose of it according to local regulations.