Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Stereo Component Amplifier Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the stereo component amplifier assembly.

WIRING DIAGRAM


E190644E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    E190870E03
  1. Disconnect the stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below .

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L108-10 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L108-5 (+B) - L108-10 (GND)
    Always
    11 to 14 V
    L108-12 (ACC) - L108-10 (GND)
    Power switch on (ACC)
    11 to 14 V

Text in Illustration 
*1
Front view of wire harness connector
(to Stereo Component Amplifier Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    E190870E02
  1. Disconnect the stereo component amplifier assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L108-9 (AMP+) - L108-10 (GND)
    Power switch on (ACC)
    Audio system playing
    8 V or higher

Text in Illustration 
*1
Front view of wire harness connector
(to Stereo Component Amplifier Assembly)


NG
Go to step 3
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR


    E190875E01
  1. Disconnect the stereo component amplifier assembly and radio receiver assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L108-9 (AMP+) - L34-9 (AMP)
    Always
    Below 1 Ω
    L108-9 (AMP+) - Body ground
    Always
    10 kΩ or higher

Text in Illustration 
*1
Front view of wire harness connector
(to Radio Receiver Assembly)
*2
Front view of wire harness connector
(to Stereo Component Amplifier Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE RADIO RECEIVER ASSEMBLY (Click here)