POWER WINDOW CONTROL SYSTEM > Key-off Operation Function Operates even if Operating Conditions are not Satisfied |
| 1.CHECK MANUAL UP / DOWN FUNCTION |
Check that the manual up and down function using the multiplex network master switch assembly and power window regulator switch assemblies can operate all the power windows (Click here).
|
| ||||
| OK | |
| 2.CHECK REMOTE UP / DOWN FUNCTION |
Check that the remote up and down function using the multiplex network master switch assembly operates the power windows (Click here).
|
| ||||
| OK | |
| 3.CHECK OPERATION FUNCTION AFTER POWER SWITCH IS TURNED OFF |
Check the power window operation function after the power switch is turned off.
| Result | Proceed to |
| When power window can still be operated even after opening driver side door or front passenger side door within approximately 45 seconds of power switch being turned off | A |
| When power window can still be operated even after approximately 45 seconds have elapsed after power switch is turned off (for All Doors) | B |
| When power window can still be operated even after approximately 45 seconds have elapsed after power switch is turned off (for Driver Side, Front Passenger Side, Rear LH Side or Rear RH Side)) | C* |
|
| ||||
|
| ||||
| A | |
| 4.READ VALUE USING INTELLIGENT TESTER (Main Body) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Door Courtesy SW | Front door courtesy switch RH signal / ON or OFF | ON: Front door RH open OFF: Front door RH closed | - |
| FL Door Courtesy SW | Front door courtesy switch LH signal / ON or OFF | ON: Front door LH open OFF: Front door LH closed | - |
|
| ||||
| OK | ||
| ||