CAN COMMUNICATION SYSTEM > Combination Meter ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Combination Meter ECU Communication Stop Mode |
|
|


| 1.CHECK CAN BUS WIRE FOR DISCONNECTION (COMBINATION METER MAIN WIRE) |
Turn the power switch off.
![]() |
Disconnect the combination meter connector.
| *1 | Front view of wire harness connector (to Combination Meter) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| L27-10 (CANH) - L27-11 (CANL) | Power switch off | 108 to 132 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L27-19 (IG+) - Body ground | Power switch on (IG) | 11 to 14 V |
| L27-18 (B) - Body ground | Always | 11 to 14 V |
| *1 | Front view of wire harness connector (to Combination Meter) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (GROUND TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| L27-30 (ES) - Body ground | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (to Combination Meter) |
|
| ||||
| OK | ||
| ||