Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR

FRONT EVAPORATOR TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE AIR CONDITIONING UNIT ASSEMBLY

HINT:
Refer to the procedure for Remove Air Conditioning Unit Assembly (Click here).



2. REMOVE BLOWER ASSEMBLY


  1. w/o PTC Heater:

    1. Disconnect the connector.



    2. Disengage the 3 screws and guide, and remove the blower assembly.


      E189130



  1. w/ PTC Heater:

    1. Remove the screw and disconnect the quick heater connector.

    2. Disconnect the connector and disengage each clamp.



    3. Disengage the 3 screws and guide, and remove the blower assembly.


      E189131E01


      Text in Illustration 
      *1
      Quick Heater Connector
      -
      -



3. REMOVE COOLER EXPANSION VALVE


    E189167
  1. Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.



4. REMOVE COOLER EVAPORATOR SUB-ASSEMBLY


    E189156
  1. Remove the packing.

    NOTICE:
    Remove the packing carefully because it will be reused.



    E189154
  1. Remove the 4screws.

  1. Disengage the 4 claws and remove the lower heater case.



    E189152
  1. Disengage the clamp and remove the cooler evaporator sub-assembly with the No. 1 cooler thermistor.



    E189151
  1. Remove the 2 O-rings from the cooler evaporator sub-assembly.



5. REMOVE NO. 1 COOLER THERMISTOR


    E189063
  1. Remove the No. 1 cooler thermistor.