Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Rear Side)

ELECTRICAL KEY OSCILLATOR (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL ELECTRICAL KEY OSCILLATOR (ELECTRICAL KEY ANTENNA)


    B229292
  1. Install the electrical key oscillator (electrical key antenna) with the 2 nuts.

    NOTICE:
    Be careful when installing the electrical key oscillator (electrical key antenna). If the oscillator is dropped, replace it with a new one.

  1. Connect the connector.



2. INSTALL REAR BUMPER ASSEMBLY


    B228482
  1. Engage the 4 claws and install the rear bumper assembly as shown in the illustration.



    B228480
  1. Engage the 5 claws.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228478
  1. Install the screw.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Engage the claw.

    HINT:
    Use the same procedure for the RH side and LH side.



    B228476
  1. Engage the 2 rear bumper upper stoppers and install the 2 screws.



    B228477
  1. Install the 9 clips.

  1. Install the nut.



3. BUMPER POSITION SETTING (w/ Intelligent Parking Assist System)
(Click here)